Concrete Cutting Perth
Clean, accurate cuts through reinforced concrete, block, brick and stone for builders, trades and homeowners across Perth and WA.
Concrete Cutting done properly
Concrete cutting is most of what we do. We cut new doorways and window openings, remove damaged sections of slab, trench floors for plumbing and electrical, and modify structures so new plant and services can go in.
Every cut is planned before we start. We scan for rebar, conduits and post-tension cables, agree the cut line with you, and set up water suppression so dust stays out of the air and slurry stays out of the drains. Our gear is chosen to keep noise, dust and vibration down, which matters in occupied buildings and close to neighbours.
Concrete Cutting · PerthWhat we use it for
- New door, window and service openings in walls
- Slab removal for repairs, extensions and plant
- Trench cuts for drainage, plumbing and electrical
- Stair, lift and riser openings in suspended slabs
- Cutting out damaged or spalled concrete
- Structural modifications for builders and engineers
The details
- Methods
- Wall sawing, floor sawing and hand sawing
- Materials
- Reinforced concrete, block, brick, stone and masonry
- Dust control
- Water suppression with slurry capture
- Before cutting
- GPR scan to locate rebar, cables and conduits
- Clients
- Commercial, residential and industrial
How the job runs
Scan
We scan with ground-penetrating radar to find rebar, post-tension cables and conduits before anything is cut.
Mark and protect
Cut lines are agreed and marked. Floors, walls and finishes nearby are covered and water suppression is set up.
Cut
Diamond saws and core drills cut to the line, with water and slurry captured as we go.
Remove and clean up
Sections are lifted out, waste goes to certified recycling or disposal, and the area is left clean for the next trade.
Concrete Cutting questions
How accurate are your cuts?
We cut to the line you mark or to the engineer's drawing. Diamond blades give straight, clean edges that usually need no patching before the next trade starts.
Can you cut inside an occupied building?
Yes. We use water suppression and slurry capture to contain dust, and we can work to agreed hours where noise is a concern.
Do I need an engineer before cutting an opening?
For openings in load-bearing walls or suspended slabs, yes. We can work from your engineer's details and we'll tell you if we think one is needed.
Do you offer concrete cutting across Perth?
Yes. We provide concrete cutting across the Perth metro area, Mandurah and Peel from our Myaree base, with regional WA by arrangement. Call 0423 303 210.
Tell us what needs cutting, where it is and when you need it done. We'll give you a clear price and a time we'll actually turn up.